The P-ad dress is used only for parameters relating to one of the four available axis in puts

The P-ad dress is used only for parameters relating to one of the four available axis in puts:


o


Bit axis


o


Byte axis


o


Word axis


o


Two-word axis


H beam high-speed Drilling


If the pa ram e ter does not re late to an axis, the P-ad dress is re dun dant and does not have to be


pro grammed in the block If more than one axis is re quired to be set at the same time, use mul ti ple


N P R en tries be tween G10 and G11 (see ex am ples fur ther in this chap ter)


R-address in G10 L50 Mode


The ad dress R in the G10 L50 mode con tains the new value to be reg is tered into the punch machine for Head se lected


pa ram e ter num ber and must al ways be en tered Busway Press Clamp Machine (no de faults) The valid range listed above must al –


ways be ob served The R-ad dress may also de fine pitch er ror data Note the lack of dec i mal points


in all ex am ples shown


Program Portability


Pro gram por ta bil ity re fers to the struc ture and con tents of a pro gram as it re lates to its ap pli ca –


tion on dif fer ent ma chines and/or con trol sys tems CNC pro grams con tain ing even a sin gle pro –


gram ma ble pa ram e ter en try should be used only with the ma chine tool and con trol unit for which


they were de signed Use ex treme care be fore using such a pro gram on different ma chines


Pa ram e ter num bers and their mean ing on dif fer ent con trol mod els are not al ways the same, so


the ex act model and its pa ram e ter num bers must be known dur ing the pro gram development For


ex am ple, on Fanuc 15 con trol, the pa ram e ter con trol ling the mean ing of an ad dress with out a dec –


i mal point is #2400 (Bit #0) The pa ram e ter that con trols the same set ting on Fanuc 16/18/21


con trol mod els is #3401 (Bit #0) – 0=the least in put in cre ment is as sumed, 1=the ap pli drilling tools ca ble unit is as sumed


The fol low ing ex am ples il lus trate var i ous pro gram ma ble pa ram e ter en tries and have been tested


on a Fanuc 16B con trol – both lathe and mill ver sions The se lected pa ram e ters are used for il lus –


tra tion only, not nec es sar ily as typ i cal a

You can leave a response, or trackback from your own site.

Leave a Reply

Sorry, no posts matched your criteria.